Skip to content
No heat? Same-day service when availableServing the Albuquerque metro
Call (505) 985-5738
Smart thermostat set to heat in an Albuquerque living room

Heating guide

Why Is My Furnace Blowing Cold Air?

(505) 985-5738

Seven common causes, the ones you can check yourself, and when to call.

Cold air from the vents is the most common winter heating call in Albuquerque. Work through these in order.

1. Thermostat set to fan ON

If the fan is set to ON instead of AUTO, it blows air even when the burners are off. Switch it to AUTO.

2. Dirty filter tripping the limit switch

A clogged filter makes the furnace overheat, so a safety switch shuts the burners off while the fan keeps running. Replace the filter and give it 15 minutes.

3. Failed igniter

Hot-surface igniters crack with age. If you hear the inducer motor start but the burners never light, the igniter is a prime suspect.

4. Dirty flame sensor

Burners light for a few seconds and then shut off. A technician cleans or replaces the sensor.

5. Pilot light out

Older furnaces and wall heaters use a standing pilot. If it will not stay lit, the thermocouple is often worn.

6. Condensate problem (high-efficiency furnaces)

A clogged drain or frozen line can shut a 90%+ furnace down. Look for water or an error code.

7. Gas supply

Check that other gas appliances work and the furnace gas valve is open. If you smell gas, leave and call New Mexico Gas Company at 888-664-2726.

When to call

If the filter and thermostat are fine and it still blows cold, call. Igniter, flame sensor and control problems are quick fixes for a technician.

Helpful links: New Mexico Gas Company rebates · PNM energy efficiency programs · CPSC: carbon monoxide safety

Cold house? Don't wait.

Get your heat back on

Furnace, heater, boiler and heat pump repair across the Albuquerque metro.

Call (505) 985-5738
Call for heating repair